Wireless Driver Issue

[chiefzod]

Hey All,

I just changed my standard drivers to wireless (2 units) and can't get either to change to slave mode. It just flashes Red/Blue off memory (communication error). I have the driver less than a cm apart so i can't really get any closer. Any ideas on how to get these things working?

 

[IceCap Service]

Unplug both units and start from step #1 on the 1st pump. Make sure pump #1 is set to Master.
Then proceed to pump #2 and start from Step#1.
One pump MUST be set to Master in order to set another pump to slave.
I just tried this on test and found if you try to set up a pump to Slave when there is no Master assigned you will get a flashing red/blue and will have to unplug the unit and start again.

 

[chiefzod]

Got it.

I had done everything as siad but didn't realize you couldn't save the master setting before setting the slave on the other.

All good now.

 

[chiefzod]

Working great now!

Have a pretty good wave going on a 150g with 2 vortechs. Will add 2 more down the track though for more flow.