6000 streams and 7094 controller

[sdorsky]

Have just set up the streams and controller and they work fine in pulse mode, but not in the interval mode. Some details are as follows; I did set up the pumps into sockets 8 and 11, did set the pulse between 1 and 5 secs, when pushing switch(13) to the topmost position the light shows green, not red, and after the final direction in the manual the two streams and controller still seem to be operating in the pulse mode.
Anyone have any thoughts? Thanks in advance...SD

 

[rvitko]

The light is supposed to be green, it was red way back when and that got skipped in a manual revision. They should still pulse but socket 8 and 10 should be lit up and then after the interval you set is over the pumps in 9 and 11 come on. You may just have a very long interval check what you have set. You may also need to power down the pumps and then plug them back in, leaving the cotnroller connected to the drivers.

 

[sdorsky]

Thanks for the quick response. I'll work on it and let you know.

 

[sdorsky]

Thanks again Roger your suggestions worked fine. Sometimes patience is required I guess.