6055s Stopped Working

[AKG10]

I have a pair of 6100s and a pair of 6055s controlled by a 7095. Both 6055s stopped working at what seemed to be the same time. I know it is not an issue of calcium build up. I regularly soak all of the pumps to remove the calcium. I have checked all of the connections without any luck. I don't think its the controller since the 6055s won't work on their own. I have also noticed the 6100s don't seem to move near as much water, although, they are getting a bit old. Any suggestions on the 6055s? Any chance these are repairable?

Thanks,
A.J.

 

[liquidlunch]

Do your power indicator lights on the power supplies light up?
Did you try another power strip or wall jack?
The chance of losing 2 at the same time is odd unless your house got zapped.

 

[rvitko]

When you soak them do you disassemble them first? It could still be calcium build up, as vinegar is unlikely to penetrate between the shaft and drive unit if the pump is not first disassembled. I would try this first. They most likely can be repaired but it would be odd to lose both at once unless the power supplies got wet or the outlet is dead or they both had calcium or sand between the shaft and drive unit.

 

[AKG10]

I always disassemble the pumps when I soak them. It does appear one power supply is not working, but the good power supply won't run either pump. There really is no chance the power supply got wet with where its located. I don't think they got zapped either because I also have the two working 6100s on that strip.

 

[rvitko]

Please send in the pumps with the power supplies and I will figure it out, be sure your return address and phone number are on a note in the box-

Tunze USA
305 Victor St
Austin, TX 78753