6100 help

[ls1boost]

I got a used tunze 6100.10 from a guy and got it home and washed up and all he gave me 2 transformers 7210 and 7310 from what i found the 7210 is the correct one not sure though.

anyway i plug in the 7210 and nothing happens manualy twist the propeller and still nothing then i tried the 7310 transformer and it runs for a couple second and then makes a loud beep and i tried the manually start the propeller and nothing it just beeps till u unplug it but you plug it back in and goes for a few more seconds then beeps.

anyone have any ideas on what the problem could be thanks in advance for any help

 

[rvitko]

Take a look at the stickied thread on cleaning and driver alarms. The 7210.202 transformer makes the pump into an old 6000, a model was never made with the 7310.302 but it would have a max flow of about 2400gph, roughly between models 6000 and 6100. If cleaning doesn't solve it, the likely issue is a dead motor or driver, neither part is available any longer.

 

[ls1boost]

thanks i took the impeller apart and there dosent seem to be any berrings in the base as the diagram shows so i lubed it up a bit and it now ran for like 10min before binding up where can you get berrings for it and what size

 

[rvitko]

No lube is used, the lube is the water in the tank. The bearing may be stuck to the bottom of the impeller assembly, it is part 3000.610, a red oring sits under it at the bottom of the well, part 3000.612, you can find these parts on tunze.com