6100x2/7094/7091 setup help

[saltyreefguy]

Does anyone have some experience in correctly setting up the 2 6100's with 7094 or 7091. I have these setup and working in a 135g cube sps tank, but i don't know if i have it correctly setup for a wave motion or similiar. I also do have a 7091 controller, if i should use that instead of the 7094, i tried my best to use the manual, but it didn't help much. thanks in advance..

 

[rvitko]

Your best bet would likely be a 6100 in each back corner aimed diagonally across the tank. Use Interval mode and plug one pump into the first socket and one into the last. Set an interval of roughly 6hrs and 3 second pulse set the top knobs to 30% and bottom knobs to 100%. Every 3 seconds the pump that is on will pulse from 30-100%, if a photocell is connected at night, one pump will stay on at 100%. Every 6 hrs the pumps will switch.

 

[saltyreefguy]

thanks, will try that out. I had the pumps plugged in the first and 3rd slot. so basically each knob and switch is tell the pump/pumps,
how much flow from low/high, and switch over to different interval hours to each other, to pulse with given percentages. are the
other remaining switch is disabled in this mode? Also, is there a link or aricle of how to set up the controller to get different types
of water flow?