6105 Controller flashing

[Sparky0028]

Roger
I have a 6105 with the separate controller, the other day the pump stopped so I cleaned it up and put back into the display tank. The pump doesn't work, voltage out of power brick is 23vdc. I tried to reset the controller but all i get is a flashing blue light, any ideas?

Thanks
Rich

 

[rvitko]

Is any other controller connected to the 7090? How old is it? With the propeller assembly removed is the metal shaft still firmly in place in the motor?

 

[Sparky0028]

It was hooked up to the 7095, but haven removed it from that. I believe the prop is still attached to the shaft.

 

[rvitko]

The propeller and magnet should pull out as one piece and a metal shaft that that spins on remains rigidly fixed in the pump. If that shaft is fused in the propeller assembly by calcium, that can cause the blinking issue.

 

[Sparky0028]

Roger
The shaft stays on the pump and the propeller spins freely. When i put the pump in water it ties to start but just a quick jerk every 30 seconds or so.

 

[rvitko]

Can you forward me a copy of the receipt? Tunze at sbcglobal dot net

 

[Sparky0028]

Roger, I believe this pump is past warranty at this point.

 

[rvitko]

It has a 2 year warranty and even past warranty we can repair it and it will be much less than replacing it.

 

[Sparky0028]

Roger, I could not find the receipt last night, I did clean the pump again and the controller stopped flash and seems to be working correctly but the pump is still dead. What are my options here?

Rich