6105 not functioning

[mnchartier]

I have a 6105 connected to a 7092 controller and the pump is not working. I did try running it without the controller, it ran for a moment then shut off. I've tried removing power and returning it numerous times and it wont start back up. I believe its a motor issue. Its been cleaned in the last two weeks as I just got it second hand last week.

 

[rvitko]

Is the pump one from pre Nov 2011 where the shaft is removable and has a blue bushing on either end and reaches to the front cover, or is it the post Nov 2011 design with the fixed shaft that is short and does not pass the top of the rotor well? My guess is the shaft is loose/wobbling either from worn end bushings or a fixed shaft that has pulled out of the motor.

 

[mnchartier]

This one is a post Nov 2011 as the shaft does not pass the well. The shaft doesn't feel loose

 

[mnchartier]

Tried to get you a picture of the shaft.

 

[mnchartier]

After putting it back together last night from taking the pictures it ran for about 45 minutes then stopped. This was with no controller connected, I was just trying to test it out. If you think its the bushings I'll order them, if you think the shaft is the issue I'll send it in, just let me know what you think. Not sure if it makes a difference it was working when I bought it and did so up until the morning I started this thread. Thanks

 

[rvitko]

I think the issue is electrical. Please send it in, include the pump and power supply. Also include a return address and phone number.
Tunze USA LLC
2121 Cole Springs Rd
Buda TX 78610

 

[mnchartier]

Thank you, I'll ship it out tomorrow morning

 

[mnchartier]

Pump should have arrived to you yesterday.

 

[rvitko]

Got it, I should get to it today.