Hi Roger,
About a week ago, I cleaned out my 6200 stream and a wavebox, by soaking both motor block and propeller in a dilute vinegar solution for a day. Then I reinstall them back into system, two days later the 6200's alarm start going off, I have double check everything, and all parts seems to be inserted properly. Later when I plug in the power I do not see any movement of the propeller, and the alarm just keep going off.
The rear end o-ring and plastic where propeller rest on was also clean, and insert back properly.
Please advice what other things can I check, before I need to mail in the 6200 to you.
P.S. I use same procedure and method to clean out both wavebox and 6200. And currently wavebox is working like what it use to.
Josh
About a week ago, I cleaned out my 6200 stream and a wavebox, by soaking both motor block and propeller in a dilute vinegar solution for a day. Then I reinstall them back into system, two days later the 6200's alarm start going off, I have double check everything, and all parts seems to be inserted properly. Later when I plug in the power I do not see any movement of the propeller, and the alarm just keep going off.
The rear end o-ring and plastic where propeller rest on was also clean, and insert back properly.
Please advice what other things can I check, before I need to mail in the 6200 to you.
P.S. I use same procedure and method to clean out both wavebox and 6200. And currently wavebox is working like what it use to.
Josh
