6205 Issue

[morpheus1969]

I recieved a 6205 a couple of months back as a warranty replacement for a 6101 that had died. I left it in the box as a spare until last night. I decided to swap out my other 6101 for the 6205 to be able to direct my flow more accurately.

Everything on the 6205 appeared to be fine for about the first half an hour, then it began to cycle off and on intermittantly. I tried swapping power sources to no avail. It continued on the intermittant mode for about 15 minutes and then died completely. I could get it to start for just a second by fiddling with the connection box (where the power and controller plug in).

Any advise?

Thanks,

~T

 

[morpheus1969]

Roger,

Just got your email on this... I will confirm if it is the shaft binding this evening when I get back home.

Thanks,

~T

 

[rvitko]

The other possibility is a loose contact at the connector, I have seen this happen before.