7095 Controller ?'s

[NewSchool04]

I just purchased a 7095 controller and expecting two used 6105 pumps early next week. I have the 7095 controller in hand and I can't figure out how the pumps plug into the controller. I have 4 connection wires that are approximately 3' long that came with the controller. How does this work?

I also am running a wavebox and the directions state that you can run the wavebox on the 7095. Does it make sense to change the controller that comes with the wavebox to the 7095?

Looking forward to upping the flow in the tank . . . a bit!!

 

[rvitko]

The 7095 will connect to the pumps the exact same way the wavebox controller connects to the wavebox pumps. The controller comes with 4 cables for up to 4 pumps.

I don't recommend connecting the wavebox to the 7095, you still have to use the wavebox controller but you can change the internal jumper of the 6091 controller to extern and connect the slave to the 7095, in this set up you can alternate between the wavebox and Stream pumps in Interval 1 mode, that is the only feature this adds and in most cases it is best to run the wavebox continuously.