7095 doesn't change channels

[pgammon]

I noticed that on Interval 2, my 7095 pulses correctly on channel one, channel two stays at 30%, but never switches back and forth. On interval 1, both channels stay on pulsing correctly, but not one on, one off.

Any suggestions? I've switched cables and made sure everything is firmly connected. Thanks!

 

[rvitko]

I might turn off night mode and make sure the interval is set to the time you expect, keep in mind you set the range with the button, but then use the knob to adjust within that range. If it works with night mode off, the photocell is either in a dark place or has failed.

 

[pgammon]

Night mode was off, when I turn on night mode, pumps operate at full power.

 

[rvitko]

Do you have any reason to believe the controller may have gotten wet? The most common being the controller was not mounted and some water entered around one of the knobs on the face.

 

[pgammon]

I would say it was highly likely that it may have gotten wet. I had a skimmer mishap not long ago, is it worth sending in for you to take a look? Thanks.

 

[rvitko]

Yes, but if it got wet the most I will be able to do is discount a replacement. To spare the cost of shipping you might just open it and check before sending in.

 

[pgammon]

Thanks Roger, I'll check when I get home.

 

[pgammon]

I finally got around to popping the back off the controller. It is nice and clean inside, no evidence that I could tell of getting wet. I suppose some moisture could have gotten in an empty port.

I'd like to send to you to have a look. Thanks.

 

[rvitko]

Please do, just include a note with your return address and phone number.

Tunze USA
305 Victor St
Austin, TX 78753