7096 pusle On-Off

[Bela N]

Is there a way to set the 7096 controller software to pulse On & off?

I tried 0%, but the software only allows me to got down to 30%.

I wave a wavebox so I am NOT trying to simulate a wave.

I have 3 pumps on the right side,at different angles, pushing to the left & 3 pumps on the left side pushing to the right. I would like channel 1 to ramp up from 0% to 80% as channel 2 ramps down from 80% to 0%. It does not have to "ramp" I would be OK with it being off & going to 80%.

How do I set this in the software?

 

[rvitko]

You should be able to set 0 and 30-100%, 0-80% would be fine, but ramp mode likely must be turned off. I would turn off ramp and then if it will not let you set 0, try manually typing in 0.