Any Apex Guru's?

[SPS911]

So I did a successful system update to 4.40
Created a Fusion account
My Dashboard showed Fusion Communication Error when I was looking for a 'Link to Fusion' button.
I clicked on "enable fusion" in Network Settings on my Apex page and then clicked the "reboot after update box"
The system hung up and never loaded, so I unplugged power to the base module.
Now the base module blinks yellow and the EB8 blinks green.

What do I do?

 

[robthorn]

Unplug everything except the base module and 1 eb8. Let it sit 5 minutes and plug it back in. Wait until it clicks on the modules and status turns green. It can take a few tries. I think it means it is stuck in bootload mode.
I do not mean unplug pumps and lights. Just display and other modules and extra eb8's.

 

[robthorn]

Did you get it working?

 

[SPS911]

No, unfortunately I had to send it back for repair. Tech-support was pretty helpful though, and they were able to get a back up base unit that I had with a broken pH port, up and running, to hold me over in the meantime.

 

[SPS911]

Apex fusion is pretty sweet though