I'm planning on pulling everything out of my 40g breeder to drill the bottom. A 1 inch hole for a 1 inch overflow and a 3/4 inch hole for a 3/4 inch return.
I would do this roughly an inch away from the back glass and about 6 inches from the sides. So that way I can get some LR piled in around the PVC that will come up.
So any advice? Any drillbits I could borrow? I'm looking for most anything to make this a painless procedure
Already have Dave ordering me some slip bulkheads (so the PVC will slide in)
-geoff
I would do this roughly an inch away from the back glass and about 6 inches from the sides. So that way I can get some LR piled in around the PVC that will come up.
So any advice? Any drillbits I could borrow? I'm looking for most anything to make this a painless procedure
Already have Dave ordering me some slip bulkheads (so the PVC will slide in)
-geoff
