Any ideas how to wire this thing?

[nomoney]

My dad bought a lifeguard seahorse pump for his pond from Foster and Smith. I'm trying to figure out how to wire it for him.
I attached 2 photos, 1 is the pump itself, the other is the back where the wires get hooked up. Any ideas?

 

[mcgyvr]

Typically there is a wiring diagram on the motor specifying which is L&N you also need to ensure its properly bonded and grounded per the manual..

Take a pic of the motor nameplate/label please

 

[Jeff000]

It's the two studs on the right side there, one will be the hot and the other the neutral.

 

[mcgyvr]

It's the two studs on the right side there, one will be the hot and the other the neutral.

I thought that part was clear...:worried: but I assumed and we know about assuming...
I thought they may need more guiding but the manual covers the specifics about wire size stipulations,etc...

 

[nomoney]

Thanks guys, its not clear though as to which is which. Mcgyvr, i'll try to get a pic of nameplate today. The pump is at my dads house, i'll have to run over there. Thanks for the help

 

[Jeff000]

Thanks guys, its not clear though as to which is which. Mcgyvr, i'll try to get a pic of nameplate today. The pump is at my dads house, i'll have to run over there. Thanks for the help

Doesn't matter which is which.