Apex Firmware Help - Not my first rodeo

[elFloyd]

Having a problem updating to new Apex firmware. I've done this a couple of time without a problem...

Operation failed with the following error information:

Only one usage of each socket address (protocol/network address/port) is normally permitted

Where do I fine the duplicated socket address usage?
--------------------------------------------------------------------------
Loading firmware file into memory
Firmware file load complete...
Calculating Apex Start Checksum Vector
Calculating Apex Start Checksum Vector complete...
The controller address is: 192.168.2.2
The controller address is: 192.168.2.2
Connecting to controller, using address: 192.168.2.2
Connecting
Connected
Sending user name
User name accepted
Sending password
Password accepted
Waiting for login to be accepted
Login successful
Placing Apex in read to receive mode
The controller address is: 192.168.2.2
Trying to connect: attempt 1

Operation failed with the following error information:

Only one usage of each socket address (protocol/network address/port) is normally permitted--------------------------------------------------------------------------
Apex Network Setup

Apex Ethernet setup
DHCP: Enabled
Hostname: Apex
AquaController IP address: 192.168.2.2
Netmask: 255.255.255.0
Gateway: 192.168.2.1
Primary DNS server: 192.168.2.1
Secondary DNS server: 0.0.0.0
HTTP port (default 80): 80

Function Result
AquaController Version: 4.03_6A10
AquaController mac address: 00:0c:11:23:08:6e
Current IP address: 192.168.2.2
Current IP mask: 255.255.255.0
Current gateway: 192.168.2.1

 

[RussM]

Something else on your pc is running a tftp service I suspect. Or maybe you had two copies of the updated running. Best bet would be to reboot then try again. If that doesn't work, reboot in Safe Mode with Networking. And run the updated that way.

 

[elFloyd]

Thanks RussM... update worked in Safe Mode.