APEX help!!

[reefjunkie42]

ok so i have set up my router, have it hard wired to the apex and have my dynDNS up...now my next question is how do i set up port forwarding to a linksys e2000 ? i cannot figure out what ip address goes where....also how do i perform a firmware update?!

 

[swearint]

Other way round. You set up the router to port forward to the Apex. I don't use a linksys, but the general idea is to log into the router. There are usually several tabs/pages of configuration settings. You want to configure it such that traffic coming in to your network on a certain port gets sent to the Apex. Check the Unofficial Users Guide stickied at the top of the forum, it has information on setting up access and also doing firmware updates. I recommend against using the standard port 80 for outside traffic, here is a thread here discussing the issue: http://www.reefcentral.com/forums/showthread.php?t=1945628

Todd