john baker
New member
How to assign sockets in the power bar and check if the values are working with the PC
Proflux 3 ex
Proflux 3 ex
assign power bar
- Thread starter john baker
- Start date
ASpec
New member
If this is a PAB power bar you must enable it first before you assign socket assignments. By default all sockets are disabled.
On the P3EX goto System -> PAB Config -> Assign Devices -> Select your PAB device, right arrow to select it, enter to save the config.
You'll have exit PLC and re-start PLC after the above commands to program/see your PAB in PLC.
Above is just the basic steps to enable it; you can also set the socket starting number, assign it to a group, etc from the P3EX. More details on this are found in the manual: http://support.aquariumcomputer.com/downloads/Description_PAB_V500.pdf
On the P3EX goto System -> PAB Config -> Assign Devices -> Select your PAB device, right arrow to select it, enter to save the config.
You'll have exit PLC and re-start PLC after the above commands to program/see your PAB in PLC.
Above is just the basic steps to enable it; you can also set the socket starting number, assign it to a group, etc from the P3EX. More details on this are found in the manual: http://support.aquariumcomputer.com/downloads/Description_PAB_V500.pdf
john baker
New member
Thanks ASpec, I have been able to use the pc to program the p3ex and i am currently assigning all the hardware, it will take most of the day as it is a large system.
Hello!
I'm from spain, so.. I dont speak a goof english! XD
I can't run my powerbarr 6 PAB correctly!
this is my PLC setup:
I don't know where is the problem.
My green led it's on and the yelow led sometimes it's on and sometimes it's off.
The wire it's a normal RJ45 pc Wire.
Do you know where it's my problem?
Thanks!
I'm from spain, so.. I dont speak a goof english! XD
I can't run my powerbarr 6 PAB correctly!
this is my PLC setup:
I don't know where is the problem.
My green led it's on and the yelow led sometimes it's on and sometimes it's off.
The wire it's a normal RJ45 pc Wire.
Do you know where it's my problem?
Thanks!
AQD_ottawa
New member
Please go to www.aquariumcomputer.com and then onto the support forum. There are many Spanish support specialist there including your local distributor.
