BTA/Clown tank build

[orthokardia]

Well I am going to take Rhett's advice and take my time planning and getting advice instead of just jumpin in and winging it on this one. So here goes.

I am wanting to build a species tank for BTA/clowns. I want it to be totally self contained and I want to be able to connect it to SPS frag tanks on each side. I am thinking 24x30x16. I would also like to be able to topview if I get brave with the acrylic work. I plan on having a wavemaker / filtration insert. I am open to any and all comments and suggestions.

A few specific questions
1. dimensions? the back 6" will be used for the insert.
2. lighting suggestions. LED, MH, T-5, other
3. algae scrubber and or chaeto for filtration

well that is enough for starts

thanks in advance for the advice.
-bart

 

[NeveSSL]

What are you planning on using for filtration?

It may be difficult to find a really good hang-on skimmer that could handle the load and provide pristine water for your SPS.

As far as lighting goes, I think that would be up to you. Personally I'm going with DIY LEDs with my new office tank to keep heat down.

I would put some more thought into the filtration if you're also wanting to do SPS tanks. I think algae scrubbers are intriguing, but I also think they're more supplemental than anything. Maybe not, though.

Brandon

 

[orthokardia]

i was thinking a diy needlewheel

 

[NeveSSL]

Gotcha. Were you planning on making one that would fit in the back section?

Brandon

 

[orthokardia]

yes it would be in the back and feed into the RDSB section. i am thinking about 6x8"square and a recirculator with a slow bleed in. i think i attached a sketch. BTW what is the best application for drawings to upload ppt?