Cable for 1-10v L port

[jameshongth]

Hi all,

May I know what cable/ cable part no. for the L1/2/3/4 port?

I'm using it to dimming my DIY LED light so need the cable for connection.

Hope someone can help.

Thanks.

 

[jameshongth]

Hi all,

May I know what cable/ cable part no. for the L1/2/3/4 port?

I'm using it to dimming my DIY LED light so need the cable for connection.

Hope someone can help.

Thanks.

At first, I thought it's RJ45 and tried but it's too big for L port.
It seem like RJ11 with 6 wires. Am I right?

 

[boboxx]

This is what Matthias has posted in the past:

Pin Function Color
1 +12V Black
2 Dimming intensity channel 1 Brown
3 GND Red
4 On/off channel 1 (relay control) Orange
5 Dimming intensity channel 2 Yellow
6 On/off channel 2 (relay control) Green

http://www.aquariumcomputer.com/Forum/showthread.php?t=894

This should give you enought info to get started

 

[AQD_ottawa]

The part number you require to make the interface is LBF-AP this has all the connections ready made for you

I dont think this is listed on the GHL direct site so email me if you want one.

 

[jameshongth]

The part number you require to make the interface is LBF-AP this has all the connections ready made for you

I dont think this is listed on the GHL direct site so email me if you want one.

I intend to connect direct from PII L1 port to my Meanwell LED driver without using LBF-AP as such I need the cable only.

 

[AQD_ottawa]

risky! one short wire and Phoof! there goes your warranty, use the box and you will not have this issue

 

[jameshongth]

risky! one short wire and Phoof! there goes your warranty, use the box and you will not have this issue

OK. Will take note.

 

[boboxx]

risky! one short wire and Phoof! there goes your warranty, use the box and you will not have this issue

Not if each of the wires are nicely soldered and heat shrink. I'm not a big fan of the terminal block connector, the wire usualy brakes off at the compression side as there is no support for the wire.