kzziboy
New member
I may get banished for saying this, but here it goes...
I bought one of those cheap RO/DI units on ebay. It was $65.
Right now it's working great. My water isn't all that bad...205 TDS.
I flushed the membrane for about 45 minutes and was getting 4 TDS water. I then connected it to the DI cartridge and it was pumpint out 0 TDS water in seconds. The unit has all quick connect fittings so it's easy to connect and disconnect. It DID NOT leak, which actually REALLY surprised me.
It is a unit that lays down on it's side. I have however rigged up a makeshift stand so it's upright. I've read it should get better contact with the DI resin.
I'm going to be sure to run a little water out of the RO membrane before I hook it to the DI cartridge because of TDS creep. That should save on DI Resin big time.
I was also concerned about prices on replacement carbon cartridges and RO membranes along with the DI resin. It all looks pretty cheap though.
I checked the waste water output compared to pure and it was about a 3:1 ratio.
I guess in closing, I realize it's no where near as sturdy of a unit as what most on this forum use. It's not an easily mounted unit. It may spring a big leak tomorrow...who knows! I DO know that I needed a unit. It was cheap, so I bought it. Time will tell. How long the cartridges last will be a huge factor.
For now though, I'm happy.
Just wanted to share my experience so far.
Thanks!
I bought one of those cheap RO/DI units on ebay. It was $65.
Right now it's working great. My water isn't all that bad...205 TDS.
I flushed the membrane for about 45 minutes and was getting 4 TDS water. I then connected it to the DI cartridge and it was pumpint out 0 TDS water in seconds. The unit has all quick connect fittings so it's easy to connect and disconnect. It DID NOT leak, which actually REALLY surprised me.
It is a unit that lays down on it's side. I have however rigged up a makeshift stand so it's upright. I've read it should get better contact with the DI resin.
I'm going to be sure to run a little water out of the RO membrane before I hook it to the DI cartridge because of TDS creep. That should save on DI Resin big time.
I was also concerned about prices on replacement carbon cartridges and RO membranes along with the DI resin. It all looks pretty cheap though.
I checked the waste water output compared to pure and it was about a 3:1 ratio.
I guess in closing, I realize it's no where near as sturdy of a unit as what most on this forum use. It's not an easily mounted unit. It may spring a big leak tomorrow...who knows! I DO know that I needed a unit. It was cheap, so I bought it. Time will tell. How long the cartridges last will be a huge factor.
For now though, I'm happy.
Just wanted to share my experience so far.
Thanks!