Cleaned pump alarm still going off

[NewbieForever]

So I took the pump from the wave box and cleaned the piece in a 50% water 50% vinegar solution. I put it all back together and 2 minutes it ran smooth. Then it started beeping again.

The impeller is different then the one in your picture from the sticky. I didnt see any clips to take that apart. I did use the screw to pull the lower ring out and cleaned it. I couldnt get the red o ring out either but it looked clean.

What should I do here, it is very new still. I have had it in use since Christmas.

 

[rvitko]

It should be like the new one piece propeller shown at the bottom of the thread, it should have part 6200.70. Normally if a pump will run for sometime the issue has to be a mechanical one, an electrical fault will usually cause the pump to not run at all. Is the bush bearing loose or perhaps the magnet is cracked?