control stream with a IKS computer??

[wrang]

Is it possible to control the stream pump with a IKS computer. IF so how do i do this?
Some extra cabels
dimmeble iks box
IKS simmod model etc

hope for a answer

Best regards from sweden

 

[rvitko]

Yes, it is possible. I don't know how though. You would have to contact IKS. I do know that if done wrong it can ruin the pump and it does void the warranty. I think blgreef (RC member) knows how.

 

[blgreef]

Iks can supply cables for the simmod that will allow it to drive a stream, The cables are basicaly a din plug with two wires and a zener diode to limit the top voltage.

Last time i ordered 4 cables IKS just charged for postage, good service

I have not used mine yet due to a complete loss of corals during a tank move so I am starting from scratch.

But a few things I plan to do when using the iks to drive a stream

Check the voltage supplied by the 7094 when running at 30% and set the simmod to supply this voltage at the low setting.

Although the upper voltage is limited by the zener I will also get the IKS to supply the same voltage as the 7094 when runnign at full power


Maybe Roger knows these values?
T


You can also do it via the dimbars just do not go below 40% but i have never used these and you are dimming a veyr high inductive load not all dimmers like this l type of load.
simmod details:

http://www.iks-usa.com/simmod.html

If I recall IKS were just charging postage for the cables, I have not been able to use my setup yet as I have had a complete Tank crash due to a move and have a very empty tank


And previous posts:

http://reefcentral.com/forums/showthread.php?s=&threadid=536627&highlight=iks

http://reefcentral.com/forums/showthread.php?s=&threadid=433550&highlight=iks

 

[wrang]

Thanks for the answers!!