Corner Reef - 3D Printed brackets of Vortech Controllers

Tradewinds

Well-known member
The Corner Reef is 3D printing brackets to hold Vortech Controllers. I picked up four earlier this week. No more Velcro! :beer:

brackets2_zpsnf0ger0k.jpg

brackets1_zpsilr8aqft.jpg
 
Last edited:
Just not a display tank. Lol! How are you doing? How's the tank?

The 180 is going good, although it was on auto-pilot for a bit, as I went to Colorado. I love it out there.

I broke down the 120 (for now) as the humidity level in the basement was at 80-85%. I didn't like running the de-humidifier all the time because it heated up my office area.

Watch it, pife just might get a dt :fun2:

I will believe it when I see it. :lol2:
 
mpcart. Did you see the color ones, or did you pick those up before I brought the color ones up there?


I haven't stopped by to see them. Great idea, though. Should have known you were behind it.

I'm definitely going to pick up two of them. I'm tired of the stupid Velcro falling off the wall.

-Mike
 
Back
Top