an411
Active member
I just wanted to make sure that the I connect my powerhead to the magnet correctly. I slide the piece that goes into the magnet and then the round piece that slips onto the top of the stream slides over the piece that I slid into the magnet correct?
Also the part that has the plug attached to it is that ok if that were to get wet its sitting on the bottom of my stand I am not sure if I should mount it somewhere will it won't get wet? The actual metal thing that the round thing gets attached to got mounted to the sid of the stand where it will not get wet?
One last thing is I am using a 7095 controller and I see on the side of the metal box that there is a control for min and max should that be set to something or does the controller bypass that and make this feature controllable only from the controller?
Also the part that has the plug attached to it is that ok if that were to get wet its sitting on the bottom of my stand I am not sure if I should mount it somewhere will it won't get wet? The actual metal thing that the round thing gets attached to got mounted to the sid of the stand where it will not get wet?
One last thing is I am using a 7095 controller and I see on the side of the metal box that there is a control for min and max should that be set to something or does the controller bypass that and make this feature controllable only from the controller?