DIY project ahead

[NittyGritty]

So, I need to build a side unit for my system that houses a clean, organized area for my apex and RW controllers and hides all cords leading to these units along with a RODI reservoir for my ATO. Has anyone seen some examples of this? If so please share!

D.

 

[Jet Black]

I built one out of a modular IKEA chest of drawers, not the best thing for water but its going to last its few years of intended use.



Both sides were meant to be shelves/drawers but instead I left the right side open and put a sliding door in font of it.



Houses the equipment and reservoir for both tanks, theres also a smaller shelf above thats useful for holding small pieces of equipment.

I cut one of the shelves from the right side to make a compartment door for electronics. Holes cut to hide and route wires, and its held on with magnets.



It doesn't look very tidy but velcro straps have actually made it 100x better.

Good luck on your project,
Justin