Does anyone know if O2Surplus is still around?

[Macca_75]

Hey guys,

Does anyone happen to know if [MENTION=261568]O2Surplus[/MENTION] is still around or contactable? I got a few boards of him for my DIY LED's years ago. Somehow I have managed to spill a few drops of water on it on 1 of the boards - To make a long story short I need his help (hopefully he has a replacement board for sale).

Anyway, if anyone knows him any chance you could please hit him up and see if he can check in and read his PM's?

Thanks in advance.

 

[oreo57]

Hey guys,

Does anyone happen to know if [MENTION=261568]O2Surplus[/MENTION] is still around or contactable? I got a few boards of him for my DIY LED's years ago. Somehow I have managed to spill a few drops of water on it on 1 of the boards - To make a long story short I need his help (hopefully he has a replacement board for sale).

Anyway, if anyone knows him any chance you could please hit him up and see if he can check in and read his PM's?

Thanks in advance.

see this:
http://www.reefcentral.com/forums/showthread.php?t=2677797

Unfortunately both O2surplus and the board schematics are MIA.

 

[Macca_75]

see this:
http://www.reefcentral.com/forums/showthread.php?t=2677797

Unfortunately both O2surplus and the board schematics are MIA.

Thanks - going through link now.

If only we could access the files. I suspect I can repair my board if I had schematics (but would be happier to buy a replacement )

Thanks again for the link

 

[oreo57]

Thanks - going through link now.

If only we could access the files. I suspect I can repair my board if I had schematics (but would be happier to buy a replacement )

Thanks again for the link

Tried finding them here..but no luck.

http://www.reefcentral.com/forums//misc.php?do=showattachments&t=2222702
to be honest.. most of th board is modules..w/ a few resistors/capacitors and diodes thrown in

1 Aduino, one bluefish mini, a microprocessor, and 6ldds/2SCR power supplies.
I know minimizing a bit..

Doubt if they would allow it but I believe his boards were done by seeedstudio
https://www.seeedstudio.com/fusion_pcb.html
or not:

For the PcB's themselves... I use Elecrow for conventional FR4 boards - http://www.elecrow.com/8 and Seeedstudios for single sided Aluminum boards - http://www.seeedstudio.com/depot/login.htm

https://community.blynk.cc/t/aka-an...3017-i-o-expander-wemos-d1-min-blynk/11562/14