hummermaniac88
New member
Ok so low psi on the angle grinder with a diamond hole saw should do just as well as the electric drill with a clutch? Right..?
Drilling tanks?
- Thread starter ryansweet
- Start date
thecoralreefer
New member
Yes the angle will work
just use some thing to hold it in place so you get a clean hole.
If you let it it will jump around before you get the groove in the glass.
I used a suction plate from an old pump and drilled it out to fit the hole saw. stick it to the glass and use a power head to keep it cool. All over a trash can so you have a sump to work from.
just use some thing to hold it in place so you get a clean hole.
If you let it it will jump around before you get the groove in the glass.
I used a suction plate from an old pump and drilled it out to fit the hole saw. stick it to the glass and use a power head to keep it cool. All over a trash can so you have a sump to work from.
hummermaniac88
New member
Well my plan is to use the hole saw to cut a hole in a piece of acylic and use that as a template, between the glass I will have a circle of plumber's putty and I'm going to pour water in the plumber putty pool, then use my angle grinder at low psi to slowly drill the hole...Good plan?
hummermaniac88
New member
Can anyone confirm this please before I start...?
