equipment housing ideas?

[gerWERM]

the stand i have is an open concept stainless steel stand. i have all the equipment including ATO resevoir off to the side. Any ideas for a type of housing that as a seperate compartment for reservoir and electrical equip?

i was thinking a small trunk or something?

thanks

 

[gerWERM]

attached is a photo of the setup in question...

 

[gerWERM]

123

 

[dmh8801]

Enclosed end table? Blanket chest? A nice vase for ATO water? Or you could skirt the stand. Just some ideas.

I'm in the middle of building two end table type of cabinets for the same reasons (one for the sump and one for ATO water). Our stand is enclosed but there's just no room.

 

[gerWERM]

Yeah, I was thinking about a trunk/bench .... Wasn't sure if maybe someone had pics or ideas of something they did already. Good luck to u as well

 

[fijisrfr]

Go to wal mart & get one of there cheap ottomans. You can cut out the bottom & just set it over your equipment. I did this with a small square one to hide light ballasts etc. also provides a little seat next to the tank!

 

[dmh8801]

Yeah, I was thinking about a trunk/bench .... Wasn't sure if maybe someone had pics or ideas of something they did already. Good luck to u as well

Thanks, Another idea if you have the space is an armoire type of cabinet. Sump at the bottom and gobs of storage above.

If your interested in what I'm doing I started a thread: http://www.reefcentral.com/forums/showthread.php?t=2425899

Be sure to post what you end up with.