29clear
New member
The truvu aquarium is peninsula shaped, acrylic, and reef ready. The dimensions are 68(L) x 29(W) x 28(H). The acrylic was polished about 4 years ago. There are some minor scratches, they can be buffed out. There was a small seam split at the top and bottom of the rear panel. The seam has been repaired. I did not have Weldon on hand when the first seam split happened at the top of the aquarium, So I had to make do with JB weld(pictured below). The section of the tank with the seam splits sit against the wall, you will never see it.
I never used the sump(I was running a canister filter). It has no baffles, and has holes drilled into it where the previous owner had run plumbing to an external pump.
The stand was custom made and very sturdy. The stand is 41 1/2 inches tall.
I'm open to offers and partial trades. I'm looking for some saltwater equipment for a new setup.
Thank you for your time.
*fish/filtration not included*
I never used the sump(I was running a canister filter). It has no baffles, and has holes drilled into it where the previous owner had run plumbing to an external pump.
The stand was custom made and very sturdy. The stand is 41 1/2 inches tall.
I'm open to offers and partial trades. I'm looking for some saltwater equipment for a new setup.
Thank you for your time.
*fish/filtration not included*
