FS: Sump

[edsbeaker]

Hi,
I needed a bigger sump for my new build, so my sump is up for sale.
This is a 36"L X 17"W X 16"H sump built 8 months ago by Anthony at Nano Sea Creations. It is set up as a split sump with return section in the center.

Drain section measures 11 1/2"L X 16 1/2"W and has dual 4" filter sock holders

The center return section measures 11"L X 16 1/2"W
The screws in the baffle were used to hold my BRS carbon and GFO reactors

The refugium section measures 8"L X 16 1/2"W

In use

Asking $125 Firm


__________________
Marilyn
Custom 140G starphire tank, cabinet and stand ordered
60"X 24"X 22"
ETA is end of March

 

[sgoodman]

Nice sump!! Just wish you was closer to Indianapolis but am afraid gas and or shipping would push the cost too high...

 

[sparky5785]

What's the baffle height in the drain/skimmer section?

Sent from my SPH-L710 using Tapatalk 2

 

[edsbeaker]

What's the baffle height in the drain/skimmer section?

Sent from my SPH-L710 using Tapatalk 2

The baffle closest to the drain section is 8 1/2"H.

 

[aaronpentz]

I'll take it if my skimmer will fit. What's the water height of the drain section to see if my skimmer will perform properly

Sent from my DROID BIONIC using Tapatalk 2

 

[edsbeaker]

PM sent

 

[sgoodman]

I'll take it if my skimmer will fit. What's the water height of the drain section to see if my skimmer will perform properly

Sent from my DROID BIONIC using Tapatalk 2

I am sure it is deep enough for just about any skimmer and if too deep just build a small stand to set the skimmer on. It would have done been gone if it was closer to me.

 

[edsbeaker]

Sump is sold pending pickup

 

[edsbeaker]

sold