LinkinReef
Member
I'm having problems with calibrating a Neptune salinity probe.
I can't seem to find any step by step instructions and the automatic calibration on the system is very confusing.
As soon as I hit "automatic probe calibration" the pop-up screen somes up saying "when ready press calibrate to start" . If I hit "start" on step 2 of 5 it starts reading but I don't know what its supposed to be reading here because it never said what is should be submerged in the first place. It just reads saying acceptable range, reading has settled and time left and at the bottom is says "dry the conductivity probe", but dry it from what?
Once I click on next, step 3 of 5, I select the solution to use which is the 53,000. Once I click on next, step 4 of 5 never gives me a green light and says error calibrating probe.
What could I be doing wrong? I've gone through Neptune's website over and over and I can't find anything on this.
I can't seem to find any step by step instructions and the automatic calibration on the system is very confusing.
As soon as I hit "automatic probe calibration" the pop-up screen somes up saying "when ready press calibrate to start" . If I hit "start" on step 2 of 5 it starts reading but I don't know what its supposed to be reading here because it never said what is should be submerged in the first place. It just reads saying acceptable range, reading has settled and time left and at the bottom is says "dry the conductivity probe", but dry it from what?
Once I click on next, step 3 of 5, I select the solution to use which is the 53,000. Once I click on next, step 4 of 5 never gives me a green light and says error calibrating probe.
What could I be doing wrong? I've gone through Neptune's website over and over and I can't find anything on this.
