System was working fine while I stuck with the display controller as my sole interface. Decided to "Get jiggy with it." Successfully installed a wireless to Ethernet unit. Was able to view info on my iPad, iPhone, and laptop. In an attempt to link to Apex Fusion, I was informed in the instructions to upgrade my firmware (not that it was old or anything b/c I've only had it for two months). Tried updating firmware using a Netgear wireless to Ethernet unit, come to find out that this is frowned upon :uhoh2:
So far I've tried to unplug and power down the base unit. Nothing. Luckily, all gizmos are running off the fallback settings that I established earlier, but my display unit is dead. Tried establishing a link directly from laptop to the Apex unit via the Ethernet cable, but laptop says the the connection is dead.
Any suggestions before I dissect the unit and yank out the Apex memory battery to get back to original factory settings?
So far I've tried to unplug and power down the base unit. Nothing. Luckily, all gizmos are running off the fallback settings that I established earlier, but my display unit is dead. Tried establishing a link directly from laptop to the Apex unit via the Ethernet cable, but laptop says the the connection is dead.
Any suggestions before I dissect the unit and yank out the Apex memory battery to get back to original factory settings?
