Matthias Gross
.Registered Member
Some customers asked me to find a solution for the problem that the PTC increases power to fast compared to the temp. deviation.
For instance they want to have full cooling power at a deviation of 2°C.
In version 4.03 is a new option "1-10V is maximum at a deviation of ..." in the temperature section.
If you enter here "2°C" then the 1-10V will output the max. voltage (usually 10V) when the measured temp. is 2°C above the desired value. In this case the voltage would be the half if the deviation became 1°C.
This option is also useful to control PropellerBreeze.
For instance they want to have full cooling power at a deviation of 2°C.
In version 4.03 is a new option "1-10V is maximum at a deviation of ..." in the temperature section.
If you enter here "2°C" then the 1-10V will output the max. voltage (usually 10V) when the measured temp. is 2°C above the desired value. In this case the voltage would be the half if the deviation became 1°C.
This option is also useful to control PropellerBreeze.
