How to unsnap the WWDbox top & base?

[CJ]

Just got my upgrade yesterday. I don't want to break the plastic case so could you please give me some pointers as to what to use and how to pry it open. Thanks.

 

[reefsafe]

Use a rectangular razor blade and pop the two halves apart. Easier to start on the left side then move to the right side

 

[EcoTech Marine]

CJ-

mdrumm's got it right. It's very simple using this technique.

-Tim

 

[CJ]

Thanks both of you but since I don't know how the two halves snap together, I don't know how or where to put pressure to unsnap them. It looks like the tab should be pushed in toward the body, then pushed down, but it won't budge.

I don't want to break the plastic. It would be nice to have a drawing, Tim.

I left my phone number on Ecotech's support voice mail before I left the house but nobody called me back. Lacking a drawing, voice contact would be helpful. Thanks

 

[reefsafe]

CJ, if you want shoot me a pm and I can help you. I think Ecotech is off for the weekend.

 

[CJ]

PM sent, mdrumm

 

[IceCap Service]

We close on Fridays at 4:00PM. Just look at where the 2 halves meet. What I use is a thin blade screw driver. Just a slight squeeze and there will be a slight gap. Slowly work the screw driver tip around to each end and gently twist the blade slightly at each corner. Each corner will unsnap. Do this at all 4 corners. When I first tried it I was a little worried myself but have never fouled one up yet.

Thanks for the assist mdrumm.

 

[CJ]

Got it. Thanks a million. You too, mdrumm.

It is a little scary, glad I'm not the only one,