illumination control

[zotiri]

hi i am going to order profilux 3.1 N megaset and i want to control my leds with illumination program but i dont know which led control i need.
i have 24 x Mean Well ELN-60-48P and 12 x Mean Well ELN-60-27P
total 36 channels profilux can control up to 32 i can union some of them no problem but the problem is
ledcontrol4passive
Max allowable difference in potential at the outputs: 24 V
Maximum current per channel: 12 mA
Number of Channels: 4
Input voltage range analog inputs: 0 V ... 10 V
PWM switching frequency: 200 Hz

Mean Well ELN-60-48P dimmable driver
0 ~ 1.3A current range
24-48V DC Voltage (runs ~8-14 LEDs)

so 24 v is not enough . also the mA
What i need ?
if ledcontrol4passive is ok to control it has 4 channels so how i get 32 channels do you know the parts i need ?
i don't need thunderstorm or wheather effects
i just want sunrise and sunset
thx.......

 

[AQD_ottawa]

Basically you would need to find a driver that is within spec of the profiLux. its the only way.

I would avoid passive units unless you fully understand electronics and pull down resistor circuits. the cost will outway buying pre made units even the Mitras!