interval program on tunze 7096

[chercm]

i have tunze 6105 on channel 1 and 3 but when it is to jump to channel 3 only , the channel 1 is also on ?

i thought it should be siwtch off but i do not have problems when the channel 1 is on , the channel 3 does not turn on .

please advice

 

[chercm]

the pump on channel 1 is continuous running bu the pump on the channel 4 is pulsing even though it is on interval , why ?

i have placed both the pumps on channel 1 and 2 but set on interval program but they always on ...

 

[rvitko]

Please double check that your program uploaded properly to the controller. Interval should run 1 and 3 at the same time and 2 and 4 at the same time.

 

[chercm]

Please double check that your program uploaded properly to the controller. Interval should run 1 and 3 at the same time and 2 and 4 at the same time.

i checked.

i am using channel 2 and 3 , the same thing happened , when the channel 3 is on ,even though the led is on channel 2 , the pump is on ....:furious:

 

[rvitko]

I don't know why this would be, the most likely cause is the controller cable is broken and not sending information to the pump so it is just running full power. Do you have another cable to try?

 

[chercm]

I don't know why this would be, the most likely cause is the controller cable is broken and not sending information to the pump so it is just running full power. Do you have another cable to try?

i am using the latest program for the controller , is it the program or the controller having the issue ?

 

[rvitko]

Without testing it, I could not know, you might try uninstalling the program and reinstalling the old one from the disk. I lean toward the problem being with a cable or pump though, a broken controller cable would let the pump constantly run at 100%, there are 5 fine wires in the cable, it only takes a strong pull or bend to break them.

 

[liver]

Does the ineterval program change the night mode at all? When I was running pulsing only the light sensor seemed to control the night program, but now I noticed my wavebox shut off before my system lights. It could have been a storm but it seems strange.

 

[rvitko]

Night mode is only activated by the lights, but Storm mode may have shut off the wavebox, Interval would have no effect.