L-port Expansion Modules and Tunze Cables

[jackiechandc]

Hi everyone,
Quick question. I bought the Lport expansion modules and have installed it into the Profilux. I lost the instructions, so a little confused here. Once I do this, the top port is L7 and the bottom port is L8 or is it the other way around?
Basically I want to install my (2) Tunze 6101s in my 4x2x2 tank. Thanks!

 

[Matthias Gross]

what do you have?
PLM2L4S - 2x 1-10-interfaces and 1 connector for powerbar
or
PLM4L - 4x 1-10V-interfaces

 

[jackiechandc]

Hi Matthias,
I'm not sure to be honest It only has 2 L port slots. Basically I ran out of L sockets so ordered an expansion slot so I can use the Tunze cables. Is there a way to tell from looking at it what expansion that I have?

 

[kidney514]

I would think that the top one is L7L8 and the Bottom is L9L10 is I was to guess.

Do you have the tunze 1 and tunze 2 cable, you would also need the splitter so that way you would waste the additional port.

If you both tunze cable are Tunze 1 the you need each port, so one pump would be on L7 and the other on L9. Be sure to configure you min to 3v and high to 8v.

Let me know all off the above is an educated guess.

 

[jackiechandc]

Yes, I have a splitter cable as I have two Tunzes. Do you know what the ideal settings would be for a 4x2x2 tank? Thanks again for your help. Take care.
Wei

 

[kidney514]

I guess you could start with that setting and see......

 

[jackiechandc]

Awesome! I'll give that a try. Thanks man!
Wei

 

[recife111]

I have two nano 6055 streams.

what cables do i need to run them.

 

[boboxx]

1x tunze 1
1x tunze 2

 

[Ed Reef]

I have 2 stream and 1 wavebox....anyone out there have any suggestion on best possible set-up?? Mine is a peninsular 200cm x 80cm so all my pumps and wavebox is at one end....