Leak Detection Setup??

[cma510]

I have an optical sensor mounted at the maximum water level in my tank. I just want the return pump to shut off when that sensor switches on. In PLC I set the sensor to "Leakage Detection". However, every instruction I read on how to set up my return pump socket says "set it to 'Water X'", where "X" is your level sensor number.

I don't have a "Water" function in my PLC software (v5.1.6.2). Right now I have the pump set to "general alarm (inverted)" .. which works, but will kill the pump on any alarm. What's the right way to do set it up for that specific level sensor, if the "Water" function has been removed?

 

[AQD_ottawa]

set the sensor to auto top off in level control
set return pump in socket function outlet to water fill
You may have to invert the socket function

I have mine set the exact same way

 

[cma510]

Kind of counter intuitive but it's working! Thanks for your help.