Level Control

[chiefzod]

Hi,

Does anyone know if there is a way to make it so that if level 3 is active than shut down socket X?

I want to make it so that if my skimmer cup gets full the Profilux will shut down my skimmer pump. That way if your skimmer goes nuts it's will shut off before you have the contents of your sump on the floor.

 

[Matthias Gross]

set the socket function to water 3

set the function of sensor 3 to ATO

 

[chiefzod]

What about the level alarm? Is there anyway to max out the time so it won't go off?

 

[Matthias Gross]

set the time to 0 -> this disables the time limit

 

[jdrabek]

Matthias,

I have been working with Lorin to set-up my float and logic to shut-off the main pump in the sump when the float drops. So it is set to ATO and I fixed the timeoverdue water 1 alarm by changing the time as stated above.

The timeoverdue water 1 was turning the socket back on after 1min regardless of sensor position. Now that I fixed that is there a way to set-up an alarm for low water level?

 

[Matthias Gross]

no, because the "low level" is a normal condition in your system setup

At the moment I have no idea how an alarm should look like to make sense in this case.

 

[jdrabek]

When the float is up that is normal condition and when the float is down is when the pump shuts off.

Set-up as ATO we were able to get the switching working properly, but when I tried as water leakage the switching of the outlet occurred when I wanted, but it would alarm in the up or normal condition. I could never get the alarm to switch on when the float dropped.