max flow from 6100

[MSHUR]

hi,roger,
i have 2 6100"s and multi controler..how should i set it up to get max flow rate?

regards,mike

 

[rvitko]

The driver has to be at 100% and this should be the case if you haven't adjusted it and the multicontroller channel the pump is on should have both top and bottom knobs at 100%

 

[MSHUR]

hi,roger
my driver set up for max,,,that i am sure..
ok,all four knobs 4a-4b and 4/b-6b has to be on 100%?
btw,do u know when u getting shipment for magnet holder?champion said ,they on back order(

mike

 

[rvitko]

The magnet holders are a problem right now because we thought it would take until February to sell 2500 units, we sold that many already and are out of the raw materials of magnets and steel plates, further the mold broke. The mold is repaired and was back in place when I left but they were still waiting on more magnets, neodymium magnets are only produced by three companies in the world so it is not so easy to attain them but they expected more to arrive in a few weeks. Only the two knobs of the channel you have pumps connected to need to be at 100%. 4a and 4b or 6a and 6b.

 

[MSHUR]

got it...
do u think for 140 g tank it would be too much flow ,if i set up for 100%?

mike

 

[rvitko]

Yes, a 6100 is a lot for a 4ft tank.

 

[MSHUR]

right now i have them set up like recomended in the instractions,,
i think 30/90 and 40-80...i am not sure thow..
do u think if i increase flow,it would be a problem,,
i have only sps in the tank,

mike

 

[rvitko]

If it has coarse sand or no sand it will be OK but do it slowly.

 

[MSHUR]

thankx..roger...