latazyo New member Mar 5, 2007 #1 I did the mesh mod perfectly as per the directions and now my pump wont work it runs, but it doesnt push any water, its like there's a problem with the impeller, etc any ideas
I did the mesh mod perfectly as per the directions and now my pump wont work it runs, but it doesnt push any water, its like there's a problem with the impeller, etc any ideas
JxMetal New member Mar 5, 2007 #4 yea if it's not spinning just trim down the mesh until it does spin. Or you can start the pump with the cap off it and then put the cap on it and it should be fine. I had to start mine like this.
yea if it's not spinning just trim down the mesh until it does spin. Or you can start the pump with the cap off it and then put the cap on it and it should be fine. I had to start mine like this.
latazyo New member Mar 5, 2007 #5 thanks guys I figured it out, the ends of the cable ties were too long, so I cut them down and now its working great its a great mod before I barely had any bubbles, now I have 1.4 x 10^8
thanks guys I figured it out, the ends of the cable ties were too long, so I cut them down and now its working great its a great mod before I barely had any bubbles, now I have 1.4 x 10^8
