MP10 flashing red/green

[ojonas81]

Sp my MP10 has started to flash red/green no matter what I do. I have tried to run it without the wetside and still the same thing. Any ideas on what can be wrong or anything else I can test?

 

[sniper2be]

how old is the unit?

 

[ojonas81]

It is bought a couple of years ago. Has been working flawlessly up until now.

 

[aquapod24]

That happened to me as well with my MP40ESW. It would blink stay on for a few seconds then turn off. It's something the dry side does to not ruin the pump. Your wet side needs to be repaired or replaced.

 

[BoxesOfTheSea]

THOROUGHLY clean your wet side and then give it a try.
To clean it, rinse it very well and then soak in 50/50 vinegar water for a few hours. Rinse well again and then give it a go. This worked for me.

 

[ojonas81]

Well I get this issue even with no wet side connected. Also already tried to clean the qt site and it sprins freely.

 

[Alex Y EcoTech]

It is bought a couple of years ago. Has been working flawlessly up until now.

Since the unit is outside of our warranty, I would recommend purchasing a new dryside motor from our online parts store found here: http://store.ecotechmarine.com/

 

[ojonas81]

So there are no troubleshooting I can do, it is dead in the water?