SALTWATERSIG
New member
So I won a mp10 es in a club raffle a couple of years ago and since then have had it upgraded to W es so it can link with my 2 other vortec pumps (mp40wes) . I was doing cleaning maintenance roughly 8 months ago (I had not put pump into use until about 4 months earlier) and noticed propeller part appeared to have calcified/fused on to the white ceramic shaft. basically I destroyed the ceramic part as it broke off in pieces leaving metal shaft exposed. I ordered and replaced the base which comes with shaft part figuring that maybe I waited too long to have maintenance done . fast forward about 3 months and again doing maintenance it seems like same parts were stuck again and after spending quite a long time soaking in vinegar I was able to pull them apart , today (appx 30 days later) again while attempting to clean pump on a more frequent schedule .....propeller part came off with a struggle as well as half of the ceramic part. Is there something I can do about this or do I just let pump run until it seizes as it appears doing routine maintenance seems to require replacing something each time
