I have two MP10s and one MP40. I wanted to place the MP40 toward the front on one end, and the MP10s on the other end, front and rear. I wanted to run them in gyre mode, the MP40 and rear MP10 set to antisynch with the front MP10. I wanted the MP10 to be master because I can set it to 100% and the MP40 to 30 or 40%, whereas if the MP40 is master at 40%, the MP10s don't exceed 40%.
The problem is that there is no variance in the speed of the MP40. Even though the speed indicator is going up and down, the speed is constant.
I programmed them using ESL. Suggestions?
Also, one of the MP10s which I bought in April this year (the other I bought in October of this year) is noisy. Sounds similar to an RC car but not as loud. I can hear it upstairs. I can't hear the other two unless I put my ear next to them.
Thanks
The problem is that there is no variance in the speed of the MP40. Even though the speed indicator is going up and down, the speed is constant.
I programmed them using ESL. Suggestions?
Also, one of the MP10s which I bought in April this year (the other I bought in October of this year) is noisy. Sounds similar to an RC car but not as loud. I can hear it upstairs. I can't hear the other two unless I put my ear next to them.
Thanks
