Mp40,apex,wxm - rookie, help needed.

[eder10986]

Ok gang. So I have the above listed equipment and for the last week has been setup.

I'm familiar with my apex as I've had it for a year but for the life of me can't figure out the mp40s. Or I don't think so at least.

They are both running off my apex right now. But don't seem to be alternating or creating random flows. They seem to be running the same even though I have one on anti sync which brings me to my next question. What does that mean?! I'm so confused and searching online doesn't seem to help.

This is the program I'm running right now.

In essence. I want help or suggestions on to how to best alternate flow and randomize t throughout the day. They are mounted on a 150 gal across from each other one about 4 inches lower than the other.

Thanks in advance.


Sent from my iPhone using Tapatalk

 

[ca1ore]

I set mine up a while back, before fusion, but I'd imagine you still need to designate one pump as the master. Anti synch then does the opposite.

 

[eder10986]

I set mine up a while back, before fusion, but I'd imagine you still need to designate one pump as the master. Anti synch then does the opposite.

Yes. This is what I read. But I can't do it or don't know if one is the master or not. Etc. Do I need to unplug them? Unlink them from wxm. Man I'm confused!


Sent from my iPhone using Tapatalk

 

[ca1ore]

I can check where to do it when I get home.

 

[eder10986]

I can check where to do it when I get home.

Thanks my friend! Doing more research meow

 

[eder10986]

Now this happened....Ugh!

I am new to the WXM and MP40's. I had them running for a couple of days and decided to reset them to make one the slave and one the master.

After I did that they unlinked from my WXM although I could still see them in my fusion.

I was unable to re connect them to my WXM no matter what I tried...unplugging my WXM, unplugging drivers, resetting drivers...they would always flash blue and yellow and never link even after pressing "set" over 20 times.

Now, my outlets are gone from my fusion, my MP40's won't link to my WXM and I am heartbroken....ugh.

Hoping someone can help me, please!

 

[ca1ore]

You don't want to do slave/master through the vortech linking, you want to do it through apex. I don't know how to do it through fusion, but when I set my profiles up through the legacy web app. I just set the 'control' to vortech and then identify which pump will be the master. I did this for both the synch and antisynch profiles, so that when I assign synch to another pump it follows the master; antisynch it does the opposite.