I just had an issue with one of my controllers being messed up by my reeflink and Ecotech replaced the controller. Well the new controller arrived today and I connected it up and updated the firmware via the Ecosmart website (Vortech Legacy) which fixed the problem to the original controller I was having issues with. When I plugged in my other MP40's one of them was flashing green and running very slowly. I have recycled the power to it and left it unplugged for a few minutes which didn't fix the problem. I also updated the firmware on this controller and again this didn't fix the problem. Reeflink is seeing the controller but it still flashes green and runs very slow. Has anyone experienced this and if so is there a way to fix it? Any advice will be greatly appreciated.
MP40w ES flashing green????
- Thread starter cdmurphy
- Start date
Alex Y EcoTech
RC Sponsor
Cdmurphy,
A light green flashing will indicate that the pump is either in Battery Backup mode or the power supply is not sending enough power to the controller. I would recommend double checking all power connections to see if this resolves the issue.
A light green flashing will indicate that the pump is either in Battery Backup mode or the power supply is not sending enough power to the controller. I would recommend double checking all power connections to see if this resolves the issue.
Hey Alex, Thank you for the response. After you mentioned the power issue I went and checked and you were totally right. I had plugged the power cord from my tunze osmolator which looks identical to the ones for the controller. Totally my mistake and I should have realized when the pump for the osmolator was running louder than normal. Thanks again for your help.
Similar threads
