Multiple adapters with different address ranges

[jmait769]

I'm trying to do the firmware update and following along in the New User Guide it states to disable all ip addresses that do not have the same first 3 octets of the IP address as the Apex does. These are the address I cannot end:

224.0.0.22
224.0.0.251
224.0.0.252
239.255.255.250
255.255.255.255

Almost the same as the example in the guide. I have turned everything off in the Sharing and Discovery section in Networks and Sharing Center, disabled wireless and I have no VPN listed in the Internet Options (Connections). How do I find these adapters and turn them off? Thanks!

Jay

 

[RussM]

Those are special addresses called multicast addresses. Don't worry about them. What you primarily want to avoid is having Ethernet and wireless connections active at the same time.

 

[jmait769]

Those are special addresses called multicast addresses. Don't worry about them. What you primarily want to avoid is having Ethernet and wireless connections active at the same time.

Thanks Russ! I hit the update button after reading this and "“ success!! :spin3: I actually had corrupt firmware causing the display to be blank which is now fixed. I did notice that I have two display modules in the Module Setup and could not delete the second module. When I try the upstatus.sht window pops up and it just continuously refreshes. Right now I'm just happy to get the display to display! Thanks again!!

Jay