My Tunze is messing with my Tunze!

[Fliger]

I put my tank back up (went barebottom, yeah!). I put my Streams in the middle of the tank sides, cranked them up (just got 2 6100 transformers, yeah!). Set up my osmolator (with my new Tunze kalk dispenser, yeah!) - and all was good ... right.

I noticed the return chamber of my sump - where I put the sensor was going up and down. I figured I had something wrong with my durso - but nope, nothing wrong there. After a few minutes I realized that when the Stream pointing towards my overflow (kind of) pushed so much water that it sent extra water into my overflow.

I know I could just reconfigure my Stream, but that would be extremely difficult at the moment. Is there anything I can do avoid this? Of does it matter? The level that my Osmo comes on now is when the other Stream is on. I think I should be OK, that point would lower with evap, right?

Can I run it this way for a week or so? I can't see how it would be a problem.

Thanks in advance,

David

ps - ordered the magnets thru Aq Arts - any idea when they might get them in? and what will the price be on them?

 

[rvitko]

I see know reason for this to be a problem. I might change it just because I am fairly anal about how my set ups work and run, I am more into the gadget end then the life end of it so that's how I do it.

I called today and got bad news on the magnet holder. I don't have a definitive release. They said they started stamping out wavebox bodies but with the current demand the machinist could not work the magnet holder into the injection molding routine at this time. They are working on it but this is a set back. I know we are adding more machines but not until a new addition is built so this is a year away. I expect this means early August for the magnet holder.