Nano Wavebox 6206

[lcktemp]

Hi,

I brought the nano wavebox brand new for 1.x years, I found that since yesterday the pump suddenly is not following the wave signal from the controller, it is now always ON (rather than ON and OFF). I switched the power supply and signals (the DIN) from my two other 6055, but it still behave the same. I have also opened the little square box to check any broken circuit, but it seems quite intact to me. So, is it a pump fault?

Please advice.

Ken.

 

[rvitko]

I am not completely clear on what you describe. Does the controller run the 6055's correctly and not the wavebox? If so this would point to a pump problem. If not, this would be a controller problem.

 

[lcktemp]

I am not completely clear on what you describe. Does the controller run the 6055's correctly and not the wavebox? If so this would point to a pump problem. If not, this would be a controller problem.

I have 2 controllers ( 6091 and 7096 ) and two 6055 pumps and seems they all are functioning properly, and so I think it is the pump problem. I have purchased a replacement in my local dealer. Thanks for your help anyway.